Stihl TS 700, TS 800 - Rubber Buffer between Front Handle and Crankcase; Rubber Buffer between Crankcase and Tank Housing

59TS 700, TS 800
The handlebar clamp (1) must be
removed first in order to remove the
rubber buffer.
1
376RA182 TG
: Take out the screws (arrows).
– Steady the nuts on the back with
a suitable wrench when
unscrewing the screws.
376RA290 TG
: Undo screw (arrow).
– Take off the rubber buffer, stop
buffer and sleeve.
376RA262 TG
: Note the installation sequence.
– Reassemble remaining parts in
reverse order.
– Tightening torques, b 3.6
376RA215 TG
Damaged rubber buffers (annular
buffers) must always be replaced.
Rubber buffer on ignition side
– Remove the fan cover, b 7.5
: Prise the plugs (arrows) out of the
rubber buffers.
376RA293 TG
: Remove the screws (arrows)
from the rubber buffers.
376RA294 TG
10.1 Rubber buffer between
front handle and
crankcase
10.2 Rubber buffer between
crankcase and tank
housing