Stihl TS 700, TS 800 - 3.6 Tightening Torques

6 TS 700, TS 800
3.6 Tightening torques
Screws can be removed and installed as often as necessary without impairing the strength of the screwed
assembly, provided that the specified tightening torque is observed.
For this reason, it is essential to use a torque wrench.
Fastener Thread
size
For component Tightening
torque (Nm)
Remarks
Screw IS-M 5x20 Starter cover / crankcase 6.0
Screw IS-M 5x58x22 Clamp / handlebar holder 5.0
Screw IS-P 4x14 Bearing, switch shaft / tank housing 2.5
Screw IS-M 5x21 Filter cover and spark plug cover 3.5
Screw IS-M 5x20 Crankcase 9.0
Nut M5 Filter base / carburetor 3.5
Screw IS-M 5x16 Cover, tensioner / cast arm 4.0
Screw IS-P 6x19 Handlebar / tank housing 6.0
Screw IS-M 5x20 Air guide shroud / crankcase 4.0
Screw IS-M 5x20 Muffler / crankcase 10.0 1)
Screw IS-M 5x20 Muffler / cylinder 10.0
Screw IS-M 4x8 Short-circuit lead / crankcase 3.0
Screw IS-P 6x19 Filter base / tank housing 5.0
Screw IS-M 5x35x12 Filter housing / filter base 3.0
Screw IS-P 5x19 Shroud / tank housing 6.0
Screw M 10x1 L Belt pulley / shaft 40.0
Screw IS-M 5x20 Fan cover / crankcase 6.0
Screw IS-M 5x20 Starter cover / crankcase 6.0
Screw IS-M 6x35 Cylinder / crankcase 12.0 1)
Screw IS-M 4x10 Cylinder / support plate diaphragm 3.0 1)
Screw IS-M 5x20 Ignition module / crankcase 8.0 2)
Screw IS-P 6x32.5 Support / handlebar / tank housing 6.0
Screw IS-M 6x16 Holder for shutoff valve / water
connection
4.0
Screw IS-M 6x35 AV element rubber buffer / front handle 6.0
Screw IS-P 6x19 AV element rubber buffer / ignition side 6.0
Screw IS-P 6x19 AV element rubber buffer / clutch side 6.0
Screw IS-M 5x20 Bearing plug / spring 6.0
Screw IS-P 3x6 Rewind spring / starter cover 0.5
Screw IS-M 3x20 Hose clip / manifold 0.8
Screw IS-D 5x16 Rubber buffer / support 6.0
Nut M 10x1 Flywheel 40.0
Nut M 10x1 Starter wheel 45.0
Carrier M 14x1 L Clutch 50.0
M 14x1.25 Spark plug 28.0
Nut M 10x1 L Belt pulley / bearing 40.0
Screw IS-M 6x28 Bearing flange / guard 8.0
Screw M 10x18 Thrust washer / abrasive wheel 20.0
Nut M 10x18 Abrasive wheel 30.0
M 10x1 Decompression valve 14.0