Stihl TS 700, TS 800 - 6. Clutch

22 TS 700, TS 800
: Remove the complete
tensioner (1).
1
376RA034 TG
: Remove the cover (1) and draw
the tensioning lever (2) off the
spring of the tensioner.
– Examine the parts and replace
them if necessary.
376RA036 TG
2 1
: Insert the hook of the tensioner in
the hole (arrow) in the lever.
–Fit the cover.
376RA037 TG
: Fit the complete tensioner (1).
– Insert the fastening screws and
tighten them down securely.
– Tightening torques, b 3.6
Note:
1
376RA038 TG
The tensioner must be in its pre-
tensioned position before installing
the bearing with guard.
– Turn the hexagon of the
tensioner as far as possible
anticlockwise to pre-tension the
tensioner.
– Troubleshooting, see b 4.1
Removal
– Remove the ribbed V-belt,
see b 5.3
– Remove the belt pulley and
clutch drum, see b 5.5
: Unscrew the clutch (1) from the
crankshaft stub with size 21
insert 5910 893 5616.
Note:
The clutch has a left-hand thread.
1
376RA039 TG
– Remove the cover washer (1)
from the crankshaft stub and
clean it if necessary.
Top
1
376RA066 TG
6. Clutch