Stihl TS 700, TS 800 - 11. Actuating Levers

62 TS 700, TS 800
Rubber buffers are fitted on the front
handle (arrow) and rear handle
(arrow) to give the machine stability.
The rubber buffers on the front
handle must always be replaced in
pairs.
376RA292 TG
: Take out the screws (arrows) and
remove them with the washers.
– Remove the rubber buffers.
376RA344 TG
: Note the installation sequence.
– Reassemble parts in reverse
order.
– Tightening torques, b 3.6
376RA352 TG
– Prise out the rubber buffer (1)
with a suitable tool.
– Wet the new rubber buffer with
Press Fluid OH 723, b 14
: Slide the new rubber buffer as far
as possible into the T-guide
376RA378 TG
1
(arrow) underneath the handle.
Stop buffer
A stop buffer is installed between
the tank housing and crankcase to
limit vibrations at the manifolds.
A damaged or missing stop buffer
must be replaced or fitted.
– The rubber buffer (1) engages
the lug and edge of the housing
(arrows).
– Reassemble parts in reverse
order.
1
376RA377 TG
– Remove the handlebar support,
b 10.1
– Disconnect the water hose from
the shutoff valve.
376RA289 TG
: Take out the screws (arrows).
376RA183 TG
: Remove the support (1) with
rubber buffer.
– Remove the front handle from the
machine.
1
376RA359 TG
10.4 Rubber buffers 10.5 Front handle