95TS 700, TS 800
No. Part name Part No. Use Rem.
29 Torque wrench 5910 890 0302 Screw connections (0.5 to 18 Nm)
30 Torque wrench 5910 890 0312 Screw connections (6 to 80 Nm)
31 Bit size 13, long 5910 893 2804 Remove and install decompression
valve
32 Bit size 17 5910 893 5610 Nut for flywheel
33 Bit size 19, long 5910 893 5613 Spark plug
34 Bit size 21, long 5910 893 5616 Clutch
35 Bit T 27 x 125 0812 542 2104 Remove and install spline socket head
screws with electric or pneumatic
screwdrivers; tighten down screws with
torque wrench
36 Screwdriver T 27 x 200 5910 890 2415 IS-P screws (4 mm) 1)
37 Screwdriver Q-SW8x200 5910 890 2420 Carburetor nuts
38 Drift pin 1124 893 7200 Remove and install deep groove ball
bearings (clutch side)
39 Drift pin 4119 893 7205 Install and remove deep groove ball
bearings (ignition side), remove ball
bearings on clutch side
40 Drift pin 4224 893 7200 Install and remove deep groove ball
bearings (belt pulley)
41 Pliers DIN 5254-A 19 0811 611 8380 Remove and install external retaining
rings
42 Assembly pin 1111 893 4700 Remove and install the piston pin
43 Insert T20 5910 893 2803 Diaphragm / support plate on cylinder
44 Flange 4224 893 2501 Seal cylinder exhaust port
45 Test wheel 5910 851 6100 Test truth of running of mount for
abrasive wheel
Remark:
1) Use only for releasing P screws
To Next Page
Loading...
