Stihl TS 410 - Tensioning the ribbed V-belt; Fitting; replacing an abrasive wheel

TS 410, TS 420
English
27
N Insert the square nut into the guide
in the guard and hold it in place
N Screw in the shorter banjo bolt (6)
and washer at the adjusting lever
and tighten up with the combination
wrench
Mount "cast arm with guard" – guard on
the outboard side
N Press the oblong holes (1) in the
"cast arm with guard" on to the
studs (2), guiding the ribbed V-belt
over the front pulley
NOTICE
The belt action must run smoothly.
N The belt tensioner (3) must sit close
to the lug (4)
N Fit the "starter cover with rewind
starter" (5) over the studs (2)
N Tighten up the nuts (6) by hand
N Push the V-belt guard (7) into place
N Screw in the bolt (8) and tighten up
Connect water connection
N Insert the longer banjo bolt (1)
through the connector (2) of the
water attachment – observe the
position of the connector
N Insert the square nut into the guide
in the guard and hold it in place
N Fit the support with the longer banjo
bolt on the adjusting lever (3) –
screw in the banjo bolt and tighten
with the combination wrench
N Insert the water hose into the guide
in the V-belt guard (arrow) from the
shut-off cock towards the guard –
avoid tight radiuses
Checking the adjustment range of the
guard
N Rotate the guard forwards and
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
“Tensioning the V-belt”.
1
1
2
2
370BA008 KN
1
2
4
3
6
6
2
2
2
370BA051 KN
6
5
8
370BA077 KN
7
1
1
370BA078 KN
2
3
370BA076 KN
A