Stihl WP 600 - User Manual

Questions and Answers

T
tsmithAug 17, 2025
Why is my Stihl WP 600 engine difficult to start?
- J
  John GrayAug 17, 2025
  If you're finding that your Stihl Water Pump engine is hard to start or its power is decreasing, consider these possibilities: There might be water in the fuel tank or the carburetor may be blocked; in this case, empty the fuel tank and clean the fuel line and carburettor. Ensure the fuel tank isn't contaminated and that you're using the correct fuel. A dirty spark plug could also be the culprit, so clean or replace it. Lastly, check the air filter and clean or replace it if it's dirty.
C
Christopher McguireAug 21, 2025
What to do if Stihl WP 600 Water Pump engine stops during operation?
- R
  rjohnsAug 21, 2025
  If your Stihl Water Pump engine stops while it's running, it could be due to a couple of reasons: The oil level in the engine might be too low, causing the oil pressure sensor to stop the engine. If this is the case, top up the engine oil. Another reason could be insufficient fuel in the fuel tank, so refuel the water pump.
F
Francisco HowardAug 26, 2025
Why is my Stihl WP 600 not pumping water?
- T
  Tommy MartinezAug 26, 2025
  If your Stihl Water Pump isn't pumping water, here's what you should check: Start by cleaning the suction strainer and hoses, as they might be clogged. Make sure there's enough water available and that the pump is connected to a water source and filled with water. Ensure you're not exceeding the maximum delivery head or suction head. Also, check that the suction hose isn't collapsed or leaking, and that it's properly connected; use an inherently stable suction hose to prevent collapse.
A
allison77Aug 28, 2025
Why is my Stihl WP 600 Water Pump engine running roughly?
- K
  Kristina PrinceAug 29, 2025
  If your Stihl Water Pump engine is running roughly, several factors could be responsible. First, verify that you're using the correct fuel. Also, check if there's sufficient fuel in the fuel tank; if not, refuel the water pump. Lastly, a dirty air filter can cause rough running, so clean or replace it.
C
Cory StevensonSep 1, 2025
How to fix Stihl Water Pump engine overheating?
- R
  Robin PayneSep 1, 2025
  If your Stihl Water Pump engine is overheating, the cooling ribs might be dirty. Clean the cooling ribs to resolve this issue.
L
Lisa NewtonSep 5, 2025
Why is my Stihl WP 600 producing heavy smoke?
- N
  nhicksSep 5, 2025
  If your Stihl Water Pump is producing heavy smoke, it could be due to two main reasons. The oil level in the engine might be too high, in which case you should drain some engine oil. Alternatively, a dirty air filter can also cause heavy smoke formation, so clean or replace the air filter.
B
Bobby PattersonSep 9, 2025
What causes excessive vibration in Stihl WP 600 Water Pump?
- A
  Andrea OconnorSep 9, 2025
  If your Stihl Water Pump experiences excessive vibration during operation, the vibration dampers may be worn. Replace the vibration dampers to reduce the vibration.
M
Melissa WellsNov 12, 2025
Why my Stihl Water Pump engine cannot be started?
- C
  christine11Nov 12, 2025
  If your Stihl Water Pump engine won't start, there are several potential causes. First, make sure there is enough fuel in the tank and that the fuel is fresh and of good quality (unleaded petrol). Check that the main switch is not set to position 0 and that the carburetor isn't overheating or iced up (allow it to cool down or warm up, respectively). Also, inspect the spark plug: it may need cleaning, replacement, or its electrode gap adjusted. Ensure the spark plug socket is properly attached and the connection between the ignition lead and plug is secure. If the engine is flooded, remove the spark plug and dry it, then set the main switch to 0 and pull the starter rope repeatedly with the spark plug removed. Finally, check if the air filter is dirty and clean or replace it if necessary. I...