StimTec NEO - Electrode Management; Electrode Care, Use, and Warnings

- 51 -
NOTE: When the using MicroCurrent or
Interferential stimulation, please consult your
doctor for directions on electrode placement.
ELECTRODES
The electrodes that are supplied with your STIMTEC
NEO Unit are self-adhesive and can be used several
times. Skin must be allowed to breathe, so the
electrodes should be removed periodically. When not in
use, the electrodes should be placed onto the clear
plastic shield.
The condition of the electrodes has a direct effect on
conductivity, and therefore the effectiveness of the
treatment. When the electrodes start to lose their
adhesive quality, it is possible to reactivate their
adhesiveness by applying a fine spray of water to the
gel side of the electrode. In time, this technique will not
work, the gel will not reactivate, and new electrodes
should be used.
WARNINGS
Do not use any electrodes less than 50mm X 50mm.
Allergic reactions to the self-adhesive electrodes can
occur even though they are hypoallergenic.
• Do not apply to broken skin.
• Do not apply electrodes to areas with less than
normal sensitivity. This could lead to setting
intensities at higher levels than intended.