Stinger Quad-Aer - Unit Operation; Starting and Stopping the Engine

8
Unit Operaon
Starng and Stopping the Engine
1. Pull the choke knob up to apply the choke. Used typically
when the engine is cold. (See gure 7) If equipped with EFI,
skip this step.
2. Turn the ignion key to posion II unl the engine starts and
then release the key. (See gure 7)
3. Turn o the choke by pushing the choke knob down. If
equipped with EFI, skip this step.
4. Allow the unit to warm up and slide the throle forward to
the desired RPM. 3600 MAX RPM! You can use a lower RPM
to slow the unit.
Figure 7
Figure 8