13
AUS
AFTER SALES SUPPORT
1300 112 534
tempo.org/support
MODEL: AFD24L PRODUCT CODE: 708457 03/2022
Getting Started (Cont.)
First connection
Place the appliance on a flat, level and dry surface which should also be heat-
resistant and non-flammable. Make sure:
– the rear oven wall is placed against a wall
– there is a 15 cm clear space at the back and sides of the appliance — you
may have to move it away from the wall or from any objects on the benchtop
– there are no objects stored on top of the air fryer oven — its exterior walls get
very hot when in use. Keep children away when using the appliance.
Connect the air fryer oven to your power supply and heat the empty appliance at
maximum temperature on the Pizza setting for 20 minutes. This will eliminate any
odours from within the appliance and also burn off any excess lubricants that may
have been used in the manufacturing process.
During this first heating process, the appliance may give off a slight odour or
smoke. This is due to the elements and components being new and is no cause for
concern. It is not harmful and will disappear quickly. Ensure good ventilation. Then
switch off and unplug the appliance and allow it to cool to room temperature.
Opening the oven door
CAUTION:
This appliance generates
heat during use. Do not
touch hot surfaces.
Always use the handle
according to the
instructions on the left.
Fig. 1
Fig. 2
Step 1: Grab the centre
of the handle from below
with your fingertips.
Step 2: Pull down the
oven door carefully.
Removing food
Always open the door fully and remove food carefully with an oven mitt.
Display
When the oven is connected to your power supply, the display will switch off and
go into standby mode two minutes after the end of a cooking cycle, or after two
minutes of inactivity.
To Next Page
Loading...
