Getting Started Cont.
Shelf Placement
To ensure the oven shelves operate safely, correct placement of the shelves between the rack supports
is imperative. The shelves should be tted facing the right direction. This will ensure that during careful
removal of the shelf or tray, hot items should not slide out. (Fig. 4)
Note: The wire shelves and the roasting tray only can be used between the rst and fth layers.
Securing the Oven to the Cabinet
Please ensure the oven is secured to the cabinet. This should be done
using the screws provided and the following steps in (Fig. 6):
1 Fit oven into the cabinet recess.
2 Open the oven door.
3 Secure the oven to the kitchen cabinet with two distance holders
“A” which t the holes in the oven frame and t the two screws “B”.
Unpacking the appliance
• This product has been packaged to protect it against transportation
damage. Unpack the appliance and remove all packaging materials
from around the oven and from inside the oven cavity. If you need
to transport the oven at a later date, please ensure it is packaged
appropriately to prevent damage.
• Keep all packaging materials until you have made sure your new
oven is undamaged and in good working order. The carton is
recyclable. Whenever possible, reuse the carton and recycle it when
disposing of the packaging materials.
• Plastic wrapping can be a suffocation hazard for babies and young
children, so ensure all packaging materials are out of their reach, and
dispose of them safely.
Note: If you sell or transfer ownership of this product, pass on these
instructions to the new owner.
OR
Fig. 4
Fig. 5
To Next Page
Loading...
