Cleaning the water inlet filters
To avoid blockage of the mesh filters at the water tap or hose after long time use,
we recommend you clean these filters every 6 months, or when the water pressure
decreases noticeably.
Other Useful Information (Cont.)
3 4
Fig. 22
1
2
CAUTION!
Before cleaning the water inlet filters, make sure you have turned off the water
supply at the tap.
• Mesh filter at the water tap end: Detach the water inlet hose (Fig. 22-1).
Take the mesh filter out of the water inlet valve and clean the filter with a soft brush
(Fig. 22-2). Then assemble the filter back into the valve.
• Mesh filter at the inlet valve: Screw the water supply hose off the inlet valve at the
back of the washing machine, turning anticlockwise (Fig. 22-3). Clean the filter with
a soft brush (Fig. 22-4). If required, pull out the filter using long-nose pliers and wash
the filter under running water.
• Reconnect the water supply hose to the water tap on your wall and to the water
inlet valve at the back of the washing machine. For more detailed connection
instructions, please refer to page 13.
To Next Page
Loading...
