Recirculating Mode
This mode is the default setting. The rangehood will operate with carbon lters
and vent the air back into the kitchen.
To ensure that the mode is correct, remove the aluminium mesh lters (see Fig.
8) and check that the two levers are in the “Recirculating” position (see Fig. 4).
Charcoal Filters
• If you intend to use the rangehood with the air recirculating back into the
kitchen, it is important that you use the charcoal lters to absorb some of the
cooking odours.
• The rangehood comes supplied with the charcoal lters already installed.
However, before you install it into your kitchen cabinet, make sure to remove
any adhesive transit support tape (if any) on the carbon lters (Fig. 11).
Removing and Installing Charcoal Filters
• To remove the charcoal lters, rst remove the aluminium mesh lters (see
Fig.8), then turn anticlockwise and pull down as shown in Fig. 12.
• To install new charcoal lters, rst remove the aluminium mesh lters
(Fig.8), then align the charcoal lters with the centre of the motors, push
upwards and turn clockwise (Fig. 13) until they lock into place.
Fig. 12 Fig. 13
Fig.11
Installation (Cont.)
To Next Page
Loading...
