8
Assembling the vacuum cleaner
WARNING: Make sure the vacuum cleaner is unplugged from the power outlet
before assembling the appliance or changing accessories.
Getting Started
Before first use
• Unpack the appliance but keep all packaging materials until you have made
sure your new vacuum cleaner is undamaged and in good working order.
Plastic wrapping can be a suffocation hazard for babies and young children,
so ensure all packaging materials are out of their reach.
• Unwind the cord to its full length and inspect it for damage. Do not use the
appliance if it is damaged. In case of damage, contact our after sales support
line for advice on examination, repair or return of the damaged product.
• Read this manual to familiarise yourself with all the parts and operating
principles of the vacuum cleaner. Pay particular attention to the safety
instructions on the previous pages.
Attaching the hose
• Insert the flexible hose into the hose
connection inlet (Fig. 1). Make sure the
projected parts on the hose are aligned.
Press the hose into the unit until it clicks
into lock position.
• To remove the hose, press the two release
buttons on each side of the hose connector
and pull out the hose.
Adjusting the telescopic tube length
• Push the handle into the upper end of the
telescopic tube (Fig. 2).
• To adjust the length of the tube, press down
the release button on the tube and while
holding it, extend the length as desired.
Let go of the release button and pull until it
locks securely into place.
Fig. 1
Fig. 2
To Next Page
Loading...
