5 SpeedTech Lights, Inc © 2019
FLARE 12
HIDEAWAY
Extension Cable (Sold Separately)
• If you are extending the main cables, just add the desired length of cable to the end of the
main cables coming out of the unit. You will solder and heat shrink the wire you are lengthening
from the unit to each additional length of extension cable. DO NOT cross connect wires.
• NOTE: DO NOT leave connectors, cables, solder points exposed to heat, moisture, or debris.
Push Bulb Mounting
• Insert Flare bulb lens through the opening of the installation location.
• Use the included hardware to mount the unit to the vehicle.
Surface Mounting w/ Flare Flange (Sold Separately)
• Push the Flange onto the Flare unit.
• Run cable through the foam pad central hole.
• Use the included hardware to mount the unit to the vehicle.
To Next Page
Loading...
