Stone TR34 - 6.22 Troubleshooting - Electrical & Remote Issues

- 46 -
6. MAINTENANCE
Bulldog
®
PROBLEM CAUSE REMEDY
Low oil alert light
on ignition switch Low oil in crankcase. Fill crankcase
Unit wont run manually
or in remote mode No power in receiver. Connect receiver power cord
Blown fuse on receiver. Replace
Bulldog has a dead battery. Replace/recharge
Broken wire. Check all wires and repair
Circuit breaker tripped. Remote ignition box and reset
circuit breaker.
Battery light on
ignition switch Faulty electric system. Short circuited wire
Dead battery. Burned out voltage regulator/
alternator
Unit runs manually, not
in remote mode Radio switch not in on position Put switch in on position
No power in transmitter. Connect transmitter power cord
and turn on ON/OFF switch
Low battery. Replace battery
Ignition switch in ON position. Remove key
Wrong transmitter. Check transmitter ID. Should
match receiver. Maximum 85
frequencies.
Suddenly stopped in
remote Out of remote range. Walk toward unit
Unit has dead battery. Replace/recharge battery
Blown fuse on receiver. Replace
Broken wire. Check all wires and repair
Not all functions work Possible chip failure in receiver box. Change receiver box
6.22 TROUBLESHOOTING contd.