To Next Page
J
Jesse MorrisSep 7, 2025
What to do if Stone Rhino PD-54 has a sulfated or worn out battery?
- CCorey RobinsonSep 7, 2025
If your Stone Construction Equipment has a sulfated or worn-out battery, replace it.
What to do if Stone Rhino PD-54 has a sulfated or worn out battery?
If your Stone Construction Equipment has a sulfated or worn-out battery, replace it.
Why Stone Rhino PD-54 Construction Equipment engine emits black or gray exhaust smoke?
If your Stone Construction Equipment engine emits black or gray exhaust smoke, it is likely due to using the improper type of fuel. Ensure that you use the proper fuel.
Why Stone Rhino PD-54 has high fuel consumption?
High fuel consumption in your Stone Construction Equipment could be due to using the improper type of fuel. Make sure to use the proper type of fuel.
What to do if Stone Rhino PD-54 has Improper type of fuel?
Use proper type of fuel.
What to do if Stone Rhino PD-54 engine is hard to start?
If your Stone Construction Equipment engine is hard to start, will not start, or starts but does not keep running, it could be due to several reasons. There might be air in the fuel line, which requires bleeding the fuel line. In cold weather, use a cold weather starting aid. If the crankcase oil is too heavy, switch to oil with the proper viscosity. Ensure you're using the correct type of fuel for the operating conditions by consulting your fuel supplier. If there's water, dirt, or air in the fuel system, drain, flush, fill, and bleed the system. You may also need to replace the filter element. Try turning the key switch to “OFF” then to “ON.” For diesel engines, dirty fuel injectors may need servicing or replacement, or the injection pump may be drawing in air, requiring you to check the...
What to do if Stone Rhino PD-54 Construction Equipment has a battery charging rate too high?
If the battery charging rate is too high on your Stone Construction Equipment, test the charging system.
What to do if Stone Construction Equipment brake stays on?
If the brake stays on in your Stone Construction Equipment, check the pump for proper charge pressure.
What to do if Stone Rhino PD-54 has no release pressure?
If your Stone Construction Equipment has no release pressure, check the pump for proper charge pressure, which should be between 220-260 psi.
What to do if Stone Construction Equipment has a faulty hydraulic pump or drive motor?
Test hydraulic pressure for 500psi at full load on drive motor with engine at full RPM. Check charge pressure 220-260 psi with engine at full RPM. Replace pump if pressure is not in specified range in hydraulic motor circuit. Check drive motors case, drain flow .5GPM max. drum, tires blocked, engine running.
What to do if Stone Rhino PD-54 Construction Equipment air filter dirty?
If the air filter in your Stone Construction Equipment is dirty, clean and/or replace it.
Identifies and explains the function of each control on the operator panel.
Essential safety procedures for operating the roller correctly.
Warns about hazards associated with high-pressure hydraulic systems.
Step-by-step procedures for starting and safely stopping the engine.
Instructions for changing the engine oil and oil filter.
Procedures for changing the hydraulic oil and filter.
Inspection guidelines for Roll-Over Protective Structures and seat belts.
Addresses common causes and solutions when the engine won't start.
General| Brand | Stone |
|---|---|
| Model | Rhino PD-54 |
| Category | Construction Equipment |
| Language | English |
