To Next Page
J
James FosterSep 7, 2025
What to do if Stone Rhino PDB-54 Construction Equipment has a sulfated or worn out battery?
- BBrandon CochranSep 7, 2025
If your Stone Construction Equipment has a sulfated or worn-out battery, replace it.
What to do if Stone Rhino PDB-54 Construction Equipment has a sulfated or worn out battery?
If your Stone Construction Equipment has a sulfated or worn-out battery, replace it.
Why Stone Rhino PDB-54 engine emits black or gray exhaust smoke?
If your Stone Construction Equipment engine emits black or gray exhaust smoke, it is likely due to using the improper type of fuel. Ensure that you use the proper fuel.
Why Stone Rhino PDB-54 has high fuel consumption?
High fuel consumption in your Stone Construction Equipment could be due to using the improper type of fuel. Make sure to use the proper type of fuel.
What to do if Stone Rhino PDB-54 Construction Equipment has Improper type of fuel?
Use proper type of fuel.
What to do if Stone Construction Equipment engine is hard to start?
If your Stone Construction Equipment engine is hard to start, will not start, or starts but does not keep running, it could be due to several reasons. There might be air in the fuel line, which requires bleeding the fuel line. In cold weather, use a cold weather starting aid. If the crankcase oil is too heavy, switch to oil with the proper viscosity. Ensure you're using the correct type of fuel for the operating conditions by consulting your fuel supplier. If there's water, dirt, or air in the fuel system, drain, flush, fill, and bleed the system. You may also need to replace the filter element. Try turning the key switch to “OFF” then to “ON.” For diesel engines, dirty fuel injectors may need servicing or replacement, or the injection pump may be drawing in air, requiring you to check the...
What to do if Stone Construction Equipment has Engine emits white smoke. Improper type of fuel?
If your Stone Construction Equipment engine emits white smoke, use proper fuel.
What to do if Stone Rhino PDB-54 brake stays on?
If the brake stays on in your Stone Construction Equipment, check the pump for proper charge pressure.
What to do if Stone Construction Equipment has no release pressure?
If your Stone Construction Equipment has no release pressure, check the pump for proper charge pressure, which should be between 220-260 psi.
What to do if Stone Rhino PDB-54 has a faulty hydraulic pump or drive motor?
Test hydraulic pressure for 500psi at full load on drive motor with engine at full RPM. Check charge pressure 220-260 psi with engine at full RPM. Replace pump if pressure is not in specified range in hydraulic motor circuit. Check drive motors case, drain flow .5GPM max. drum, tires blocked, engine running.
What to do if Stone Construction Equipment air filter dirty?
If the air filter in your Stone Construction Equipment is dirty, clean and/or replace it.
Explains safety messages, signal words (Danger, Warning, Caution), and general safety rules.
Outlines essential practices for safe operation of the roller to prevent accidents.
Covers pre-start checklists, fluid checks, and engine warming procedures before operation.
Details checks for engine oil, air filter, fuel, hydraulic oil, and engine coolant levels.
Guides on visual inspection, mounting, starting, operating, and shutting down the roller.
Comprehensive guide to all operator controls, gauges, lights, and alarms for effective use.
Addresses problems related to engine not starting, starting/stopping, and power issues.
Solutions for steering, brake, and hydraulic system malfunctions.
Troubleshooting for issues with the battery, charging, and overall electrical system.
General| Brand | Stone |
|---|---|
| Model | Rhino PDB-54 |
| Category | Construction Equipment |
| Language | English |
