P46: Lower limit of the following value for 0 or 10V at analogue output
If the following value drops below this limit, the output voltage is according to parameter P47.
P47: Output voltage for values lower than P46
Output voltage below the limit set with parameter P46.
P48: Upper limit of the following value for 0 or 10V at analogue output
If the following value goes above this limit, the output voltage is according to parameter P49.
P49: Output voltage for values higher than P48
Output voltage above the limit set with parameter P48.
P50: Hysteresis at the limit values P46 and P48
The here adjusted hysteresis is set symmetrically at the setpoints according to parameters P46
and P48.
Pr
Program version
To Next Page
Loading...
Need help?
General
