13
(5) "INCLINE 3/5/8/12/15"
When the belt is running, pressing one of these 5 buttons will automatically adjust the
belt inclination to the desired level ("shortcut inclination selection").
(6) "Safety Key"
If the key is not in the correct position, the treadmill cannot be started. If necessary,
remove the key and the treadmill will stop immediately (at higher speeds it may take
several seconds for the treadmill to come to a complete stop).
(7) "PROG" (you can press and hold until the desired program appears)
Press the "PROG" button to select one of the 20 preset programs P1-P20 or the
BODYFAT TESTING program. When the "PROG" button is pressed for the last time, "FAT"
appears. In this mode, the machine will help you find out the approximate value of your
body fat. Confirm the mode selection by pressing the "MODE" button. Then use the
"SPEED +/-" buttons to specify the parameters of the person to be measured (F1 - sex:
male = 1 / female = 2, F2 - age, F3 - height, F4 - weight), confirming each value by
pressing the "MODE" button. Immediately after entering and confirming the last value,
the message "F5 - - -" will appear, at this point place both hands on the heart rate
sensors. After a moment, the display will show the value (percentage) of body fat of the
person being measured.
You can adjust the individual countdown modes (initial values) using the SPEED or
INCLINE buttons. After selecting one of the modes, press the "START" button to confirm
your choice and the belt can be started. When the countdown goes from the initial value
to zero, the belt will beep and slowly stop.
To Next Page