STORZ & BICKEL Volcano Quick Start Manual

2 pages

To Next Page

2. Choose temperature 3. Grind substance 4. Fill Filling Chamber

max. 10 mm

min. 1 mm

max. 1/2 inch

min. 1/16 inch

5. Insert Filling Chamber Insert

approx. 5 sec.

6. Preheat substance

if control lamp is off

7. “Click” Valve Balloon

on Filling Chamber

Watch vapor density

9. Remove full Balloon Unit 10. Detach Valve Balloon

from Filling Chamber

11. Caution! Hot surface!

Never leave Filling Chamber

on VOLCAN O

12. “Click” Mouthpiece

on Valve Balloon

1. Switch heat on

(takes 3-5 min.)

www.storz-bickel.com

Quick Start Manual for

STORZ & BICKEL GMBH & CO. KG · In Grubenäcker 5-9 · 78532 Tuttlingen/Germany

Refer to the Instructions for Use for important safety and user advice. Do not operate the device without ﬁrst reading and understanding the Instructions for Use!

Other manuals for STORZ & BICKEL Volcano

Instructions For Use27 pages

Questions and Answers:

C
ckentJul 27, 2025
What to do if no aerosol is formed in STORZ & BICKEL Volcano?
- J
  James WilliamsonJul 27, 2025
  If no aerosol is forming, ensure the set and actual temperature are correct. Verify that the Filling Chamber and Valve Balloon are correctly attached. Check if an extract (aromatic oil) has been added to the Drip Pad, or if there is fresh, unused plant material in the Filling Chamber. Also, confirm that the pump is turned on. Check whether the Screen in the Filling Chamber Cap is clogged or is not inserted into the notch properly. Finally, ensure the Filling Chamber has been cleaned according to the Instructions for Use.
J
James TylerAug 10, 2025
What to do if there is no green light on my STORZ & BICKEL Vaporizer?
- J
  John HaynesAug 10, 2025
  If there's no green light on your STORZ & BICKEL VOLCANO Vaporizer and the heater or pump won't activate, several factors could be at play. First, ensure the main power is on and the fuse is working correctly. Check the set and actual temperature settings to make sure they're appropriate. Also, verify that the Filling Chamber and/or Valve Balloon are correctly attached. If none of these steps work, press a button to activate the device, as it automatically switches off after 30 minutes of inactivity. Inspect the Filling Chamber Screen for clogs and proper insertion, and ensure the Filling Chamber is clean. If internal fuses are triggered, send the VOLCANO to the Service Center.

STORZ & BICKEL Volcano Specifications

General

Heating System	Convection
Weight	3.5 lbs (1.6 kg)
Type	Desktop Vaporizer
Warranty	3 years
Temperature Range	104°F - 446°F (40°C - 230°C)
Compatibility	Dry Herbs, Concentrates
Material	Stainless steel
Dimensions	7.1 x 7.1 x 7.9 inches (18 x 18 x 20 cm)
Power Supply	AC adapter (100-240V, 50/60Hz)

Related product manuals

STORZ & BICKEL Venty

29 pages

STORZ & BICKEL CRAFTY

2 pages

STORZ & BICKEL Plenty

20 pages

STORZ & BICKEL Mighty

19 pages

STORZ & BICKEL Crafty+

33 pages