Insert the tip of the strap beneath the Slide Table along the Right Bandway. Release the
strap immediately after the strap has been inserted. Do not hold the strap during tensioning
as fingers might be caught between the strap and the package which may result in injury.
1.
2 . After one strapping cycle (tensioning, cutting and sealing) is completed, a fixed length of strap will feed
3.
WARNING
Operation
After turning on the Power Select Switch, the heater element will reach operating temperature in
approximately 45 seconds.
This will start the strapping operation and the tensioning of the strap around the package.
Insert the free end of the strap into the groove of the Right Bandway.
Place the package to be strapped on the Upper Tables and over the sealing point (Slide Table).
After strapping all of your packages, turn off the Power Select Switch.
Strap length is adjustable by the Feed Length Dial and FEED Switch .(see page 6
or
)
forward automatically for the next strapping operation.
9
To Next Page
Loading...
