Need help?Do you have a question about the Strapack i-10 and is the answer not in the manual?
Thanks for purchase and emphasis on proper use and maintenance of the strapping machine.
Importance of reading manual and understanding safety warnings before operating the machine.
Details warning labels affixed to the machine, their positions, and meanings.
Critical safety warnings for power cables, strap handling, machine movement, and alteration.
Advice against use in wet environments and importance of using specified power supply cable.
Safety protocols for servicing, requiring only trained personnel.
Warning to turn off power before any repair, inspection, or cleaning.
Precautions against touching moving parts, hot components, and strap hazards.
Advice to stop operation during lightning and perform regular cleaning.
Describes the main power switch and its green indicator lamp status.
Explains the function of the reset switch for cycling the sealing unit.
Details the jog switch used to feed the strap forward manually.
Explains how to adjust the length of strap fed at the end of each cycle.
Describes how to adjust the strap tension by turning the dial.
Explains the different states of the error lamp and their meanings.
Step-by-step instructions for switching the machine to SOFT tension mode.
Explains how the error lamp indicates the selected tension mode.
Explains the heat seal process and checking seal efficiency related to heater temperature.
Describes adjusting heater temperature based on working environment and climate.
Notes that heater adjustment may be needed for different PP-strap specifications.
Explains the seal time dial for prolonging cooling before strap release.
Details fuse function for overload protection and the replacement procedure.
Safety warning about turning off power before loading the strap coil.
Initial steps for connecting power and starting the machine cycle.
Procedure for resetting the machine and confirming completion of the cycle.
Instructions for threading the strap tip through specific machine points.
Steps for inserting the strap and feeding it, including a safety warning.
Warning against holding the strap during tensioning to prevent injury.
Instruction to place the package and insert the free end of the strap.
Explanation of automatic strap feeding after a cycle is completed.
Instruction to turn off the power switch after completing all strapping operations.
Specifies how to order parts by part number, description, and quantity.
Details the format and meaning of STRAPACK part numbers for identification.
Explains abbreviations and dimensions for common hardware used in the parts list.
Illustrates harness connections from the IC board to motors and other components.
Shows harness connections from the power supply board to various machine parts.
Diagrams detailing the connector layouts present on the IC board.
Diagrams detailing the connector layouts present on the power supply board.
General| Model | i-10 |
|---|---|
| Category | Packaging equipment |
| Type | Automatic Strapping Machine |
| Cycle Time | 1.5 seconds |
| Strapping Material | Polypropylene |
| Tensioning Force | Adjustable |
| Power Supply | 220V, 50/60Hz |
| Dimensions | 750mm |
| Strap Width | 5mm - 15.5mm |
| Strapping Thickness | 0.45mm - 0.75mm |
| Sealing Method | Heat Sealing |
To Next Page
