Strasbaugh Machine Description
Version 4.0 - February 1998 2 - 43
The slurry supply connection is a large 1/2" tube connection located near
the perimeter of the slurry cart cover with a stainless steel tube extending
down toward the bottom center of the slurry reservoir. This line should be
connected to the inlet port of the diaphragm pump. The slurry main return
is also a large 3/8" tube located opposite the slurry supply connection on
the slurry cart cover. This tube should be connected to the slurry return
connection on the slurry dispensing manifold on the machine. Finally, the
slurry filter return is a small 1/4" tube which connects to the center of the
cover. This tube should be connected to the fitting on the slurry valve
assembly labeled filter return.
Both slurry systems should be completely connected before operating the
machine.
To Next Page
Loading...
