Strasbaugh Operator Functions
Version 4.0 - February 1998 3 - 49
Select the Auto Polish Cycle Menu:
Operator Action Explanation/Screen Display
1. <F9> Press the F9 key to choose
“Select Menu”.
2. <F1> Display the Auto Polish Cycle
Menu by pressing the F1 key to
select “Auto Cycle”.
Screen displays the Auto Polish
Cycle menu.
Load cassettes and place on send elevators:
3. Load 1 or 2 cassettes with wafers (polish side down or per
supervisor instructions).
4. Open the Elevator Access Operator Door.
5. Holding by top handle, place cassette(s) on send elevator(s),
making sure cassettes are seated in elevator notches.
Notes:
If one cassette is being used, it may be placed on either the right
or left send elevator.
Send cassettes may be either full or partially filled.
6. Place the cassette sensor arm(s) down on top of the cassette(s).
7. Place 1 or 2 empty cassettes (as needed) on the receive
elevators, making sure cassettes are seated in elevator notches.
8. Place the cassette sensor arm(s) down on top of the cassette(s).
9. Close the Elevator Access Operator Door.
To Next Page
Loading...
