Strasbaugh Operator Functions
Version 4.0 - February 1998 3 - 73
Assumptions - The procedures below were written with the assumptions
that:
• The operator has read the Basic Operation section of this
chapter (above).
• The operator has installed the polishing pad. (See the Operator
Routine Maintenance section, below, for procedures).
1 - POWER UP
Following the steps found in the Basic Operation section of this chapter,
above, power up the machine.
2 - PERFORM HOME SEQUENCE ROUTINE
Following the steps found in the Basic Operation section of this chapter,
above, home the machine.
3 - LOAD PAD CONDITIONING DEVICES ON SPINDLES
Following the Place Carriers On Spindles procedure, found in the Basic
Operation section of this chapter, above, place conditioning devices on
spindles by substituting conditioning devices for carriers in the procedure.
4 - RETRIEVE A STORED RECIPE
Following the steps found in the Basic Operation section of this
chapter, above, retrieve a stored recipe.
Note: To set or confirm recipe parameters, follow the procedures found in
the Machine Setup chapter of this manual.
5 - AT THE MACHINE PARAMETERS MENU, SET AUTO CYCLE
OPERATION TO CONDITION
At Page 1 of the Machine Parameters Menu, select Auto Cycle Operation
and choose Condition.
To Next Page
Loading...
