Strasbaugh Operator Functions
Version 4.0 - February 1998 3 - 75
OPERATION OF A CARRIER CLEANING CYCLE
Note: Carrier cleaning is available on single table machines only.
Repeat the procedure for Operation of a Table Conditioning Cycle Using the
Conditioning Arm, above, making the following substitutions:
• Load a recipe with carrier cleaning enabled. (Carrier cleaning
parameters are set at the Conditioning/Cleaning Parameters
Menu.)
• When running a cycle at the Auto Polish Cycle Menu, select
“Clean Carriers” (the F6 key at the choices display) instead of
Condition Pad.
OPERATION OF A SPINDLE FLUSH CYCLE
Repeat the procedure for Operation of a Table Conditioning Cycle Using
The Conditioning Arm, above, making the following substitution:
• When running a cycle at the Auto Polish Cycle Menu, select
“Flush Spindles” (the F5 key at the choices display) instead of
Condition Pad.
To Next Page
Loading...
