Strasbaugh Machine Setup
Version 4.0 - February 1998 4 - 5
“ON THE FLY” RECIPE PARAMETER CHANGES
A number recipe parameter changes may now be made while the machine is
operating.
For example, past, present, or future polishing steps can be changed. If the
current step's time is changed to a longer time than what has transpired, the
remaining time showing will increase by the same amount as the increase. If
the current step's time is shorter than what has transpired, the step will end.
Many conditioning and machine parameters may be changed. However,
changes that could cause trouble, such as changing the number of spindles
used, will be ignored until the start of the next cycle.
Finally, all polish alarm parameters can be changed in the Alarms Menu.
MACHINE SETUP
The Machine Setup Menu contains machine setups that are commonly
changed as part of machine operation but are not process related. (Machine
settings which are seldom or never changed reside in the
Calibration/Configuration Menu.)
To Next Page
Loading...
