Strasbaugh Troubleshooting
Version 4.0 - February 1998 5 - 3
“LEFT SPINDLE SPEED LOW ALARM” - # 3 35
“LEFT SPINDLE SPEED HIGH ALARM” - # 4 35
“RIGHT SPINDLE SPEED LOW ALARM” - # 7 35
“RIGHT SPINDLE SPEED HIGH ALARM” - # 8 35
“TABLE TEMP LOW ALARM” - # 9 36
“TABLE TEMP HIGH ALARM” - # 10 36
“TABLE SPEED LOW ALARM” - # 11 36
“TABLE SPEED HIGH ALARM” - # 12 36
“SLURRY 1 FLOW LOW ALARM” - # 13 37
“SLURRY 1 FLOW HIGH ALARM” - # 14 37
“SLURRY 2 FLOW LOW ALARM” - # 17 37
“SLURRY 2 FLOW HIGH ALARM” - # 18 37
“SLURRY 1 pH LOW ALARM” - # 15 38
“SLURRY 1 pH HIGH ALARM” - # 16 38
“SLURRY 2 pH LOW ALARM” - # 19 38
“SLURRY 2 pH HIGH ALARM” - # 20 38
“CONDITIONING ARM POSITION ERROR” - # 50 39
“LEFT SPINDLE VACUUM SWITCH OFF” - # 51 40
“RIGHT SPINDLE VACUUM SWITCH OFF” - # 52 40
“SEND CASSETTE(S) NOT ACTIVE” - # 53 42
“ROBOT TOP/BOTTOM NOT AT ZERO” - # 54 42
“LEFT SPINDLE NOT UP” - # 55 43
“RIGHT SPINDLE NOT UP” - # 56 43
“AXIS 1 SERVO AMPLIFIER FAULT” - # 57 (Left Spindle) 44
“AXIS 2 SERVO AMPLIFIER FAULT”- # 58 (Right Spindle) 44
“AXIS 3 SERVO AMPLIFIER FAULT” - #59 (Bridge Travel) 44
“AXIS 4 SERVO AMPLIFIER FAULT” - #60 (Table) 44
“ROBOT TRAVEL NOT HOMED” - # 63 45
“ROBOT TOP AXIS NOT HOMED” - # 64 45
“ROBOT Bottom AXIS NOT HOMED” - # 65 45
“ROBOT UP/DOWN AXIS NOT HOMED” - # 66 46
“WAFER FOUND ON ROBOT” - # 67 46
“BRIDGE TRAVEL NOT HOMED” - # 68 46
“POLISH SECTION OPERATOR DOOR OPEN AT START” - # 69 47
“ELEVATOR SECTION OPERATOR DOOR OPEN AT START ” - # 70 47
“SLURRY 1 SUPPLY LOW OR ABSENT” - # 72 47
“WAFER AT LEFT SND ELEVATOR” - # 100 48
“WAFER AT RIGHT SND ELEVATOR” - # 101 48
“WAFER AT LEFT RCV ELEVATOR” - # 102 48
“WAFER AT RIGHT RCV ELEVATOR” - # 103 48
“TABLE DRAIN OVERFLOW FAULT” - # 104 49
To Next Page
Loading...
