Maintenance Model 6DS-SP Planarizer
3 - 18 Version 4.0 - February 1998
CONTROL COMPUTER
The section below introduces the control computer and provides a brief overview
of each of the sixteen 6DS-SP 4.25 software menus.
WHERE TO FIND MORE INFORMATION ON THE
SOFTWARE...
For a detailed introduction to the 4.25 software, refer to the Operator Functions
chapter of the 6DS-SP Operations manual.
Note: For post-4.25 software versions, feature descriptions and information
contained in the 6DS-SP User Interface Reference documentation
take precedence over information in this manual.
To find information on a specific menu, see the Menu Information Locator
Table in the Contents section at the front of each manual volume.
For information on 4.25 and post-4.25 software version features, refer to the
6DS-SP User Interface Reference documentation, located in Appendix A of
the 6DS-SP Maintenance manual.
Note: With each new 6DS-SP software release, replace the 6DS-SP
Calibration /Configuration Reference and 6DS-SP User Interface
Reference documentation found in Appendix A of the 6DS-SP
Maintenance manual with the new documentation received in the
software release.
WHERE TO FIND MORE INFORMATION ON THE
CONTROL COMPUTER SYSTEM...
The system unit of the control computer is detailed in the Control System
Description chapter of the 6DS-SP Maintenance manual.
To Next Page
Loading...
