Maintenance Model 6DS-SP Planarizer
9 - 58 Version 4.0 - February 1998
7. Test the adjustment by repeating Section B., above.
a. If the input is on, skip to When Satisfactory Adjustment Is
Achieved, below.
b. If the input is off, correct it by following the adjustment procedure
in this section, lowering the switch one notch each time until the
input is on when the conditioning arm is in up position.
D. WHEN SATISFACTORY ADJUSTMENT IS ACHIEVED
• Go on to the Device Arm Park Position Switch, immediately below.
DEVICE ARM PARK (HOME) POSITION SWITCH
A. BEFORE YOU BEGIN
TOOLS REQUIRED
• 5/64-in. hex key
• Phillips screwdriver
• precision scale
TURN MACHINE POWER ON
Follow the procedures detailed in the Operator Functions chapter of the 6DS-SP
Operations manual.
To Next Page
Loading...
