Maintenance Model 6DS-SP Planarizer
9 - 60 Version 4.0 - February 1998
6. Test the adjustment by repeating Section B., above.
a. If the input is on, skip to When Satisfactory Adjustment Is
Achieved, below.
b. If the input is off, correct it by repeating the adjustment procedure
in this section, moving the switch in
.1-in. increments each time until the input is on when the
conditioning arm is in park position.
Repeat adjusting and testing until the input is on.
Note: DO NOT HOME when you power up to read the input
status.
D. WHEN SATISFACTORY ADJUSTMENT IS ACHIEVED
• Go to the Pneumatic Adjustments chapter of this manual and perform
the Conditioning Arm adjustments found in that chapter.
To Next Page
Loading...
