Strasbaugh Troubleshooting
Version 4.0 - February 1998 13 - 17
MACHINE HALTS DURING CYCLE WITH POWER
STILL ON BUT MOTION SUSPENDED - PART A
Problem
Indicator
Problem
Location
Component/ Cause Resolution/
Responsibility
MACHINE
LIGHTS AND
SCREEN
DISPLAY ON
BUT MACHINE
MOTION
STOPS
Interior of
machine
(1) Cycle paused--
(suspended)
by:
* Polish Section
Operator door
opened during cycle
halt.
* Elevator Section
Operator door
opened, preventing
elevator/robot
movement.
OR
CYCLE HALT
button on the
Control Panel
pressed.
(1a) If needed, close
operator door.
(1b) Press the CYCLE
START button on the
Control Panel.
OPERATIONS
* Notes on Opening Doors:
Opening a service door at any time shuts power down to the entire
machine, including the control computer.
Opening a polish area operator door during an auto polish cycle
interrupts and suspends the cycle.
Opening an elevator area operator door during an auto polish cycle
does not interrupt polishing, but it does suspend elevator movement and
robot movement.
To Next Page
Loading...
