2 MA_VEB100-1-2-2W-4-5_A3-1_190627_en.doc
3.7 Presser ............................................................................................................................. 35
3.7.1 Replacing the presser shaft (Fig. 12) ................................................................. 35
3.7.2 Adjusting the presser (Fig. 13) .......................................................................... 36
3.7.3 Adjusting the material support arm ................................................................. 37
3.7.4 Setting the pre-tension of the spring in spring-loaded plungers ..................... 38
3.8 Pneumatic lifting ............................................................................................................. 38
3.8.1 Setting the lifting ............................................................................................... 38
3.9 Thread trimmer (Fig. 16) ................................................................................................. 39
3.9.1 Removing and remounting of the thread trimmer drive (Fig. 16) .................... 40
3.9.2 Adjustment ........................................................................................................ 40
3.9.3 Replacing the knife (Fig. 16 und Fig. 17) ........................................................... 41
3.9.4 Cutting position (Fig. 17) ................................................................................... 41
3.10 Interval gear (Fig. 15) ...................................................................................................... 41
3.10.1 Setting the interval gear (Fig. 15) ..................................................................... 41
3.11 Sewing drive .................................................................................................................... 42
3.12 Seam lock (Fig. 18) .......................................................................................................... 42
3.12.1 Setting the feed dog at the seam lock .............................................................. 43