22
DELIVERING THE POWER
STROM LIMITED
THERMOSTAT COMMISSIONING
Once you are happy that the receiver has been tted and wired in
accordance with this installation manual you will need to commision the
thermostat, test pairing and ensure the following has been completed:
1. Power has been restored to the receiver.
2. Ensure the thermostat is powering on and responding to user input.
3. Check the pairing between the control and receiver.
4. Set the mode of the thermostat.
5. Set the advanced functions as required.
6. Leave a copy of these instructions with the controller for the
homeowner.
INSTALLATION GUIDE
To Next Page
Loading...
