28
DELIVERING THE POWER
STROM LIMITED
REPAIRING THE THERMOSTAT
If the thermostat is indicating a problem with the wireless link please follow
the repairing sequence:
1. On the wireless reciever press and hold the M/A button for 10
seconds until the green light begins to ash.
2. Enter the engineers mode of the thermostat.
3. Using the function button cycle to either AH, A3, A5 or AL.
4. Press & hold the function button for 5 seconds.
If you are successful the thermostat will display “OK”, however in the
event that “Er” is displayed the pairing has been unsuccessful. If pairing is
unsuccessful please move the thermostat closer to the receiver and repeat
the process again.
INSTALLATION GUIDE
To Next Page
Loading...
