OSD Transparency: To set the OSD transparency from Off ~ 40% with 10% steps.
Load Default OSD Setting:
Press OK to clear all OSD settings and reset to default values.
7.3.7 Auto Standby
Auto Standby is a new feature that helps you reducing power consumption. When set to 30Min/1
Hour/2 Hours or 3 Hours, the receiver will switch to standby if it doesn’t receive any commands during
this time. Set Auto Standby to Off to deactivate the automatic standby function.
7.4 Tools
Press MENU in viewing mode to enter the Main Menu.
Select the Tools submenu with pq and press OK or u to enter.
Use pq to highlight the submenu of choice and press OK proceed.
Press EXIT to leave.
7.4.1 Information
This submenu shows receiver specific information such as hardware version and software version. It
also displays our web address www . strong . tv. Please have the Information screen on hand when you
call our hotline. The person who answers your call might ask for the information given in this screen.
7.4.2 Load Factory Settings
This option allows you to reset the receiver to factory settings, which clears all stored channels.
Warning: By resetting your receiver to factory default, all your settings and stored
channels will be permanently deleted. Please use this option with care.
Use pq to select Load Factory Settings in the Tools menu and press OK. You are asked to input your
PIN code.
Input the correct PIN code using the 0~9 (DEFAULT PIN: 1234). A confirmation window is displayed.
Select Yes to return to factory settings. Select No to cancel.
Press EXIT to leave.
7.4.3 S/W Upgrade by OTA
This receiver is equipped with an Over The Air software upgrade function. An Over The Air update
might not be available in your region. Please visit our website www . strong . tv or contact your local
service hotline for more information about this option.
7.4.4 Upgrade by USB
This feature allows you to upgrade receiver software via the USB port. When new software is available
for your receiver, it can be downloaded from our website www . strong . tv.
Place the software file (unzipped) in the root directory of your USB storage device (HDD, memory
stick etc.) and connect the device to the USB port of the receiver.
Select Upgrade by USB from the Tools menu and press OK to proceed.
17
To Next Page
Loading...