Problem Possible cause What to do
After moving the receiver to
another room/area you are no
longer able to receive digital
reception
Antenna signals are too weak
The signal strength/quality
might be less than before, if
using an indoor antenna.
Press the INFO button on
remote 3x to call up signal
bars and adjust antenna for
(maximum) reception
or rescan channels
When using an active antenna,
check antenna power.
Try to use an outdoor antenna.
The receiver switches off
automatically.
Auto Standby function
enabled.
Disable auto standby. See
section 7.3.7 for details.
Playback of video (or Timeshift)
is causing picture freeze/macro
blocks or similar distortion,
especially on HD content.
Read/write speed of your USB
device could be too low.
Make sure to use a USB storage
device with sufficient speed
and space. Pen drives (‘USB
sticks’) may not support
sufficient speed.
9.0 TECHNICAL SPECIFICATIONS
Demodulator
Demodulator: COFDM; 16 QAM/64 QAM, QPSK
Transmission mode: 2 K - 8 K
Video Decoder
Profile level: MPEG-2 MP@ML, AVC/H264HP@L4.1, MPEG4 ASP supported
Video resolutions: 480i / 480p / 576i / 576p / 720p / 1080i / 1080p / By Native TV /By
source
Decoding & Video out: PAL
Aspect ratio: 4:3 Letterbox, 4:3 Pan & Scan, 16:9, Auto
Audio Decoder
Audio support: AAC/Dolby Digital Plus*/AC3+/PCM
MPEG MusiCam Layer II
Sampling rate: 32, 44.1, 48 KHz
Audio mode: Stereo, Mono
*Dolby and the double-D symbol are registered trademarks of Dolby Laboratories
Tuner
Front End: DVB-T, UHF & VHF Tuner
Input frequency range: 174 – 230 MHz (VHF) and 470 - 862 MHz (UHF)
Loop through frequency range: 47 - 862 MHz
Input signal level: -20 ~ -84 dBm
23
To Next Page
Loading...