6.7.3 Timer recording*
There are 2 ways to set a timer:
Programming a record timer via the EPG
The easiest way to record an event is via the EPG. Press the EPG button to open the EPG, then use
pq to select a channel. After that, press t u and use pq to select an event. You can book a record
timer by pressing 4. If you press 4 again on this event, the timer will be disabled. The set time of
timer is xed and cannot be modied.
Programming a record timer via the Timer menu
If you want to programme a record timer via the timer menu, press the BLUE button from EPG to
open it. You can also select it via the MENU button on the remote control in viewing mode, option
Timer in the menu Settings. This way you are free to programme start and stop time. For further details
about this menu, please refer to chapter 7.3.6 Timer in the user manual.
6.7.4 Playback*
After a recording has been made you will nd a new folder Records created on your external USB
storage device. By pressing u in viewing mode you can access this folder directly. Inside the Records
menu the following functions are supported:
pq To select a recorded event.
OK Starts playback in preview and again in full screen mode.
3 Stops playback
RED Opens the option menu to select and deselect for deleting a recorded le(s).
This menu item opens only if you have selected rst a le by using pq.
Marks a recording for deletion. When all recordings you want to delete are
marked, select Deleted Selected press OK. A message will appear to conrm
deleting. By pressing OK again the recordings will be permanently deleted
from your external USB storage device. Select Cancel if you don’t want to
delete them or select once more OK to denitely delete.
* This user manual describes the full functionality including the recording function and may not be applicable if the
software for recording via USB has not yet been installed (available in our web shop: www.strong.tv).
7.0 MAIN MENU
The main menu gives you access to Installation, Channels, Settings, Multimedia and Network functions.
To access the main menu, press MENU in viewing mode. Throughout the main menu, 9 can be used
to get back to the previous screen and to quit.
7.1 Installation of channels
Use t u to select the main menu item Installation.
Use pq to highlight the submenu of choice and press OK to select. These submenus are available:
Manual Search, Auto Search, Information, Factory Settings and Freenet Menu
13
To Next Page
Loading...