7.3 Settings
Press MENU in the TV mode and use t u to select Settings. Use pq to highlight the submenu of
choice and press OK to select.
7.3.1 Language
This menu allows you to set up your language preferences.
OSD Language: Use t u to select the language for the On Screen Display.
1st Audio language: Use t u to select the audio language you like to hear as rst priority, if
available.
2nd Audio language: Use t u to select a language that will be played when the language selected
at 1st Audio language isn't available.
Subtitle Type:
Select the preferred subtitle type to be displayed automatically. Select Normal
or Hard of Hearing*
Subtitle Display: Select On to activate displaying of subtitles.
1st Subtitle Language: Use t u to select the rst preferred subtitle language.
2nd Subtitle Language: Use t u to select the second preferred subtitle language.
* Availability of DVB/Hard of Hearing subtitles depends on the broadcast. If such subtitles are not supported, then most
likely subtitles can be activated via Teletext if available.
7.3.2 Output Settings
Use this menu to match your receiver to your TV set and/or home cinema set.
The following settings are available:
HDMI Resolution: Select the video resolution of your TV screen. The options are: Auto
(automatic detection of video resolution oered to the receiver) and manual
selections 480i, 576i up to 1080p Please use a setting that matches the
specications of your TV. Selection above 576i is only applicable to the HDMI
output.
Aspect Ratio: Select the aspect ratio of your TV. The options are: 4:3 for 4:3 screen and 16:9
for 16:9 TV sets.
Aspect conversion: Select the preferred conversion method. The options are: PanScan: displays
16:9 widescreen broadcasts in full screen on a 4:3 TV. Letterbox: black bars
on top and bottom of the picture on a 4:3 TV. Combined: shows a mix in-
between. Ignore: shows as it is.
Connection: Select the connection to your TV set. Select HDMI or TV SCART. TV SCART will
provide RGB on SCART. If the connection type HDMI is selected, then only the
CVBS signal will be available on the TV SCART.
OSD Transparency: To set the OSD transparency from O ~ 50% with 10% steps.
OSD Timeout: Sets the time after which on screen banners and messages disappear. The
range is 3~10 seconds.
HDMI Audio Output: Toggles between PCM and Bitstream output. When PCM is selected, all digital
audio will be converted to stereo audio. Bitstream enables you to listen or
17
To Next Page
Loading...