Strong SRT 8541 - 7.4.2 Record Setup

Movies:
RED Subtitle: During the playback of a movie with external subtitles, press the RED button
Subtitle to enter the subtitle menu. In this menu you can select size and
colours of your preference.
GREEN Jump: Press the GREEN button Jump to open the Jump By Time menu. You can
select a time where you'd like to jump to.
YELLOW Hide: Press the YELLOW button Hide to remove or call the timeline information
banner.
BLUE Audio: Toggles between Stereo, Left, Right and Mono audio channel output.
Music:
pq: Enter the folder with music les. Use the pq to select a le and press u or
OK to start playback. To stop playback press 3.
Pictures:
pq: Enter the folder with picture les. Use pq to select a picture. If the format
is supported it shows the picture in the small picture-in-picture screen. Press
OK to watch it in full screen mode.
RED Option: Before the playback of a picture in full screen, you can setup a slideshow/
diashow. Press the RED button Option to enter the sub option menu Slide
change Time. Select time of the slide show or switch this function o. After
you select a time, press OK and show starts to play. Press the  button to
stop.
* STRONG cannot guarantee the playback of les although extensions are listed, as it depends on codec, data bit rate and
resolution used (all MPEG codec formats are supported).
7.4.2 Record Setup*
This menu is only accessible if you connect a USB storage device. Here you can setup Timeshift and
recording.
The following settings are available:
Timeshift Status: Choose between Enable to activate the Timeshift function or Disable to switch
it o. This function will also automatically be set to Enable if you press 2 on
the remote and have USB device connected.
Timeshift Step: Select the time size step in minutes and seconds which you like to make by
using t u during navigation in Timeshift modes. Use the 0~9 buttons to
enter the time.
Timeshift Duration: Select the maximal time (size) which is reserved for the Timeshift function.
Use the 0~9 buttons to enter the duration.
Record Duration: Select the default maximum time for recordings that can be started with the
4 button. Use the 0~9 buttons to enter the duration.
Start Record earlier: If you want to start the recording, set under timer from EPG some minutes
earlier than the time obtained from the programme guide.
End Record later: If you want to stop the recording, set under timer from EPG some minutes
later as time obtained from the programme guide.
21