>> Note: Mounting clips MAY be riveted to shelf or
header. In such instances, simply remove LED light
from mounting clips by pressing against flange part
of clips with thumb.
Replacement of LED lights:
Attach magnetic mounting clips onto LED light.
Adjust magnetic mounting clips so they are
equally spaced on LED light.
Reattach LED light assembly to its shelf/header.
Position properly in shelf/header.
>> Note: If mounting clips are riveted to shelf (or
header), attach by placing LED in base of clip and
then snapping into clip at FLANGE SIDE.
Press plug’s barrel-shaped insert deep into LED
light.
Important: If plug is not inserted ALL THE WAY
IN the LED light’s orifice, the light may not ener-
gize. See “BAD” vs. “GOOD” insertion illustra-
tions below-right.
Turn LED light switch back on.
14
LED LIGHT FIXTURES, CONT’D: ‘PLUG-IN’ INSTRUCTIONS
No Gap
Gap
LED Light
Plug
LED’s Barrel
Shaped Insert
Magnetic Mounting
Clip View #2
LED
Lights
B
C
Magnetic Mounting
Clip View #1
B
To Next Page
Loading...