Stryker 1188 Series User Manual

5
Cleaning: Manual
1. Brush
• Thoroughly brush the exterior of the device with a soft-
bristled brush, focusing on any mated or rough
surfaces.
• Inject any lumen or mated surface a minimum of five
times with at least 50mL of the detergent.
• Brush any lumens a minimum of five times from each
end, using an appropriate bottle brush.
• Brush any movable parts in their extreme open and
closed positions.
2. Rinse
• Rinse the device with treated water at ambient
temperature to remove all detergent residue. Flush any
lumens or mated surfaces a minimum of 5 times. Once
all detergent residues have been removed, continue to
rinse for a minimum of 30 seconds.
• Drain excess water from the device and dry it using a
clean cloth or pressurized air.
• Visually inspect the device for cleanliness, paying close
attention to hard-to-reach areas. If visible soil remains,
repeat steps 1 and 2.
3. Soak
• Prepare a non-enzymatic detergent, according to the
manufacturer’s recommendations of 0.25 ounces/gallon
tap water at 35 – 40°C.
• Fully immerse the device and inject any lumens and
mated surfaces with at least 50mL of the detergent.
• Soak the device for a minimum of 15 minutes.
4. Brush
• Thoroughly brush the exterior of the device using a
soft-bristled brush.
• Inject the prepared detergent into any cannulae,
lumens, or mated surfaces a minimum of 5 times.
• Brush any lumens a minimum of 5 times from each end,
using an appropriate bottle brush.
• Actuate the device, brushing around any movable parts
in all extreme positions.
5. Rinse
• Thoroughly rinse the device with treated water until all
detergent residue is removed. Flush any lumens or
crevices 5 times. After the detergent residue is removed,
continue rinsing for a minimum of 30 seconds.
• Drain the excess water from the device and dry it with a
clean cloth or pressurized air.

Stryker 1188 Series Specifications

General

Brand	Stryker
Model	1188 Series
Category	Medical Equipment
Language	English