Strymon CONDUIT - Front Panel Controls and Connections; DIN MIDI IN;OUT Ports

ADDITIONAL INFORMATION
USING CONDUIT WITH A COMPUTER
When USB is connected, the computer will recognize 6 MIDI I/O ports.
• Conduit MIDI Ports 1-4 correspond with the 1/4" TRS jacks numbered 1-4.
• Conduit MIDI Port 5 corresponds with the 5-DIN MIDI IN/MIDI OUT ports.
• Conduit MIDI Port 6 will appear as a background USB communication port.
WHAT’S IN THE BOX
• Conduit MIDI hub
• Four (4) 18" right-angle to
straight TRS cables
• One USB Type-C to USB-A
Male cable
FEATURES
• One opto-isolated 5-pin DIN MIDI interface (IN and OUT ports)
• Four 1/4" TRS bi-directional MIDI ports
• Five MIDI status indicator LEDs
• One USB Type-C to USB-A Male cable
• Lightweight, compact anodized aluminum chassis with threaded
mounting hardware
• Drill Template
• Two (2) mounting screws
• Four (4) rubber feet
• Quick Start Guide
• Strymon sticker
Port 6 is a background
communication port
used for updating
Conduit’s firmware.
The diagram above shows how the MIDI ports corresponding to each of the
devices connected to Conduit will show up in your computer/DAW.
MIDI PORTS
• Conduit (PORT 1)
• Conduit (PORT 2)
• Conduit (PORT 3)
• Conduit (PORT 4)
• Conduit (PORT 5)
• Conduit (PORT 6)