Version No. 1.0
Page 40 of 51 User Manual STS Safe Series all Equipment 2023 V1.1
Factory Default Settings
Levels:
0 = 0.5uSv/hr
1 = 2.5uSv/hr
2 = 5uSv/hr
3 = 25uSv/hr
4 = 50uSv/hr
5 = 250uSv/hr
6 = 0.5mSv/hr
7 = 2.5mSv/hr
8 = 5mSv/hr
9 = 25mSv/hr
11.2 Operational Controls
The Safe-MiniSource is designed to be simple to use and as such
has only a power on/off (press and hold to turn off) button and a
LED and a variable dial. The LED shows Green to show the source
is switched on and working and that the battery level is ok. The
LED will turn Red when the battery life is low and will extinguish
once the batteries are exhausted.
To change the activity level use a small flat blade screw driver to rotate the
dial to the desired setting.
11.3 Maintenance
The Safe-MiniSource does not contain any user serviceable parts and as such
no repair or adjustment should be attempted as this will both invalidate the
warranty and lead to potential damage of the circuit.
The batteries are accessed through the panel on the rear of the instrument by
removing the 4 screws ion the corners. The Safe-MiniSource uses 2 alkaline
AAA cells, professional or long life cells are recommended for best performance.
Batteries should be removed when not in use for prolonged periods and partially discharged
cells should never be mixed with new cells.
To Next Page
Loading...