STT Pro 360 - Vertical Settings

To Next Page

To Previous Page

Superset

- Vertical Settings

[ 5]

• Place unit against vertical surface so it faces you, the lettering on the face

("Pro 360, etc.) should read from bottom to top

• Align with an edge or line - wait 10 seconds

• Press HOLD button until [ 5] appears

[ 6]

• Roll the unit so it faces away from you, the lettering should still read from

bottom to top

• Align with same edge or line - wait 10 seconds

• Press HOLD button until [ 6] appears

[ 7]

• Rotate unit end-for-end so it faces you, the lettering should now read top to

bottom

• Align with same edge or line - wait 10 seconds

• Press HOLD button until [ 7] appears

[ 8]

• Roll the unit so it faces away from you, the lettering should still read top to

bottom

• Align with same edge or line - wait 10 seconds

• Press HOLD button. [ 8] will very briefly appear, followed immediately by

regular angle measuring.

Pro 360