E-8
AUTOMATIC RESUME FUNCTION
If the CD Player turns off during playback due to power failure or the CD door accidentally
being opened, you can resume playback from the same position after restarting the unit or
closing the CD door again. Auto resume also works if you turn the CD Player off and want to
continue listening at a later time.
ANTI-SHOCK PROTECTION
This player incorporates an electronic anti-skip circuit to prevent interruption of the sound
output when the unit is subjecting to shock, vibration or rolling during CD playback. The anti-
shock system will automatically activate when a disc is playing, the ESP indicator will appear
on the LCD DISPLAY (#5).
Once the anti-skip buffer is full, it will give you approximately 60 seconds of protection against
interruption of sound output. If the player is subjected to shock or rolling for longer than the
buffer memory, some interruption of sound output will occur. This is normal and to be
expected and the sound will resume once the player has stabilized from the shock or rolling
disturbance.
Note: The anti-skip function provides for continues sound output when the unit is subjected
to shock or vibration. It will not compensate for errors arising from the use of defective,
scratched or dirty discs.
RADIO OPERATION
1. Tap POWER ON BUTTON (#7) to turn on the unit.
2. Tap the CD/FM BUTTON (#10) once to select FM mode when the unit is at CD mode, the
FM radio frequency appears on the LCD DISPLAY (#5).
3. To manually tune to a specific radio station, tap the TUNER or BUTTON (#1 or #2)
repeatedly. Use the manual tuning method to tune in weaker stations that are bypassed
during Automatic Tuning.
4. To automatically tune to the next available radio station, press and hold the TUNER or
BUTTON (#1 or #2) for 1-2 seconds until frequency readout on the display begins to
scan and then release the button. The tuner will stop scanning when it receives the next
broadcasting station of adequate signal strength.
5. Press the volume control VOLUME +/– BUTTON (#13/#14) to the desired volume level.
TIPS FOR BEST RECEPTION
The headphones cord acts as an aerial and must be fully extended for best reception.
PRESET RADIO STATIONS
1. Tap POWER ON BUTTON (#7) to turn on the unit.
2. Tap the CD/FM BUTTON (#10) to enter FM mode when the unit is at CD mode, the FM
radio frequency appears on the LCD DISPLAY (#5).
3. Tune to the desired radio station either by “manually” or “automatically” tuning method.
4. Tap the PROGRAM/ MODE BUTTON (#8), the preset memory number flash on the LCD
DISPLAY (#5). (Note: P01 will blink in the display if you are programming preset for first
time).
5. Tap the PRESET or BUTTON (#3/#4) repeatedly to select the preset number you
want to assign the station to.
To Next Page
Loading...
Need help?
General
