Six algorithms are available, four simulating a particular type of “real world” space, and two
simulating mechanical reverb plates.
The nature of the reverb can be modied further by altering its EQ: separate LF and HF swept
shelving lters (labelled LS and HS respectively) are provided. The Gain controls set the amount
of cut or boost; the Freq controls set the lter’s shelving frequency. The two graphs give a visual
indication of the frequency response:
Pre Delay may also be added: this delays the start of the reverberation without aecting the
original “dry” signal.
Note: An alternative method of assigning reverb is to apply it to one of the STEREO ouput busses.
All channels that require reverb can then be routed to that STEREO output bus. Full details can be
found in the User Guide.
To Next Page