EasyManua.ls Logo

Su-Kam DSP SINEWAVE - Page 8

Su-Kam DSP SINEWAVE
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE: - Never disconnect the battery cables while Home UPS is delivering
power or battery charger is operating. The ON/OFF switch has no effect on
the charger, it turns OFF only the Home UPS. To disconnect the batteries for
service
a) Turn OFF the power switch.
b) Disconnect all AC power.
c) Disconnect all the battery cables.
Enhanced Features
! Battery Management Protocol (BMP)
Su-kam Home UPS has highly advanced battery management
algorithm that is designed to prevent damage to batteries and extend the
useful life of your batteries by regulating the charging voltage and current.
Batteries can overheat if the charge rate is too high.
! ATM Charger
ATM stands for Auto Trickle Mode. ATM with pulse charger is used
for the first time in Home UPS. ATM with pulse charger, charges the
battery to its full capacity and after charging, it maintains the battery at its
float voltage level, so the water loss in battery is very less.
! Auto Reset
Su-Kam Sine Wave Home UPS has auto reset function in case of
Overload, Low battery. It will reset the Home UPS in fault condition
automatically and will make 4 attempts for the same.
! Automatic Protection
Low battery cutout, high battery cutout, over current and short circuit..
Enhanced Features
Installation
&
Enhanced
Features
(10)
DSP Sine Wave Home UPSDSP Sine Wave Home UPS
! Intelligent Thermal Control
Su-Kam Sine Wave Home UPS senses the overheating and displays the
warning with buzzer beep. It also automatically shutdown the Home UPS
in case of over temperature.
! Auto Power Saving
Fan control system takes care of operation of fan when ever necessary.
This saves your power and also enhances the life of fan.
! AC Mains Cut-Out
Su-Kam Sine Wave Home UPS continuously monitors the AC mains
Voltage. When AC voltage falls below the preset level, the Home UPS
automatically transfers from AC to DC power. This cut out voltage is
Factory preset as Per technical specification mentioned on Page 15.
Enhanced
Features
(11)
DSP Sine Wave Home UPSDSP Sine Wave Home UPS
REV. 25-04-08REV. 25-04-08

Related product manuals