PAGE 97
700-3 SERIES - BASE UNITS
(CONTINUED)
NOTE: If “
EECC
” (Error Code) is displayed, see Error Code
Table on next page.
NOTE: If “
EEEE
” is displayed in place of temperature, ther-
mistor in that location is faulty.
NOTE: If “
SS
r” is displayed in place of temperature, unit is
in Showroom Mode.
NOTE: Diagnostic Mode will end 10 seconds after last
key stroke.
NOTE: To clear Error Indicators, repair problem then switch unit
OFF and back ON. To clear Error Codes, press bell ON/OFF key
for 15 seconds.
To Next Page
Loading...
